■ Application:
Transparent insulation sleeve provides encapsulation,inspect, strain relief, and insulation Pre-fluxed solder provide controlled soldering process.One piece design, it consists of transparent heat shrinkable sleeve and fluxed solder. Provides insulation and lower the installed cost. Color hot-melt glue on two ends of heat shrinkable tube, connecting wires to component terminals, such as motor tabs, connector pins, and switch terminals.Step Down design make it easy to connect big size and small size wire or one wire connecting two wires.
■ Characteristics：
●Shrinkage ratio 2：1
●Waterproof for wiring splices
●Transparent sleeve provides precise inspection
●Easy control soldering process
●Minimum Shrink Temp. 60℃
●Minimum Fully Recover Temp.110℃
●Fully melt temperature of solder: 138℃
■ Technical Data:
| Operating temperature | -55℃~125℃ |
| voltage Resistant | ＞600V |
| Protection type | IP67 |
| Volume Resistivity (Ω cm): | ≥10 15 |
| Dielectric Strength (KV/mm) | ≥25 |
■ Size:
| Product Code | Size Code Color item 3 |
L(mm) |
Qty Item 2 | Φ A Min (mm) | Wire Dimensions (mm) |
Cable size AWG (mm2) |
||
|---|---|---|---|---|---|---|---|---|
| B Min | B Max C Max |
C Min | ||||||
| HP-SST-105- SD | Blue/Red | 40 | 1 | 4.5 |
1.3 | 4.5 | 1.2 | 22-14(0.5-2.5) |
| HP-SST-105- SD | Blue/Yellow | 40 | 1 | 4.5 | 1.3 | 4.5 | 1.2 | 22-14(0.5-2.5) |
Other sizes are available upon request.
●Item 1 : Heat shrinkable Sleeve , Transparent ,Radiation cross-linked modified polyolefin.
●Item 2: Solder Ring with flux
●Item 3: Glue rings
■Color:
Standard color: White, Red, Blue,Yellow
Other colors are available upon request.